CleanAll Sanitizer

Garbage Dumping sites


Remove bad odors without leaving traces in the residual water, so that the water Treatment following steps would not be affected​

1% Dilution of our CleanAll Sanitizer will disinfect and remove bad odors from the Sludge in Water Treatment Plants:

1 Cubic Tank of CleanAll Sanitizer to make 100 cubic tanks of Solution ready to use and spray over Sludge to treat 50 m3 of Sludge produced​

  • Dilute 1% CleanALl Sanitizer in Water, i.e 10 litres in 1m3 of water (you would need two of these for a normal working day)
  • Spray (fine mist) the diluted solution on Sludge in the collection Trailer tank (size 7 m3 max) throughout its filling process. The Spraying rate to be 20 litres per m3 of sludge, so for a trailer of 7 m3, 140 litres are to be sprayed throughout the filling process of the Trailter (not all 140 litres sprayed at the end of filling).
  • Same rate also applies on Grit and Grease (20 litres per m3)
  • Spray (fine mist with power) every end-of-day on the stack accumulated in the Collecting Cell (size up to 50 x 25 m2), on top of collecting cell, a volume of 1,000 litres of the diluted product. It is essential that this final spraying to be done daily, irrespective of the amount of Sludge, Grit or Grease added to the Cell.
  • Total Volume used per normal day at the Zahle Wasterwater Treatment Plant with its 50x25 m2 Collecting Cell, where 7 x Trailers of Sludge are being dumped (7 x 7 m3), to be 7 x 140 L for the Trailer + 1,000 (end of day on the surface of cell) = 980 + 1,000 = approx. 2000 litres (i.e 2m3 of he 1% diluted Solution)
  • This fine mist spraying will mix and react with the sludge, passing through the dried top surface, to reduce odors but still totally react and degrade without leaving traces of decontaminant in the residual water